From d801c429d837e0ff1cead889fea2f7362a91950e Mon Sep 17 00:00:00 2001 From: Jagan Teki Date: Thu, 9 Jul 2020 13:27:15 +0530 Subject: [PATCH] siemens: etamin: Enable DM_SPI, DM_SPI_FLASH Enable DM_SPI, DM_SPI_FLASH for siemens etamin board. Build is fine, but not tested. Cc: Samuel Egli Signed-off-by: Jagan Teki --- configs/etamin_defconfig | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-) diff --git a/configs/etamin_defconfig b/configs/etamin_defconfig index ee31e26c80..583331d7ff 100644 --- a/configs/etamin_defconfig +++ b/configs/etamin_defconfig @@ -8,6 +8,7 @@ CONFIG_SYS_MALLOC_F_LEN=0x2000 CONFIG_ENV_SIZE=0x2000 CONFIG_ENV_OFFSET=0x980000 CONFIG_SYS_SPI_U_BOOT_OFFS=0x20000 +CONFIG_SPL_DM_SPI=y CONFIG_AM33XX=y CONFIG_SYS_MPUCLK=300 CONFIG_TARGET_ETAMIN=y @@ -28,6 +29,7 @@ CONFIG_SYS_CONSOLE_INFO_QUIET=y # CONFIG_DISPLAY_BOARDINFO is not set CONFIG_ARCH_MISC_INIT=y CONFIG_SPL_I2C_SUPPORT=y +CONFIG_SPL_DM_SPI_FLASH=y CONFIG_SPL_SPI_LOAD=y CONFIG_SPL_WATCHDOG_SUPPORT=y CONFIG_SPL_YMODEM_SUPPORT=y @@ -44,7 +46,6 @@ CONFIG_CMD_GPIO=y CONFIG_CMD_I2C=y CONFIG_CMD_MMC=y CONFIG_CMD_NAND=y -CONFIG_CMD_SF=y CONFIG_CMD_USB=y # CONFIG_CMD_SETEXPR is not set CONFIG_CMD_DHCP=y @@ -60,24 +61,27 @@ CONFIG_MTDPARTS_DEFAULT="mtdparts=omap2-nand_concat:512k(spl),512k(spl.backup1), CONFIG_CMD_UBI=y # CONFIG_DOS_PARTITION is not set CONFIG_OF_CONTROL=y +CONFIG_SPL_OF_CONTROL=y CONFIG_OF_EMBED=y CONFIG_DEFAULT_DEVICE_TREE="am335x-draco" CONFIG_ENV_IS_IN_NAND=y CONFIG_SYS_REDUNDAND_ENVIRONMENT=y CONFIG_SYS_RELOC_GD_ENV_ADDR=y +CONFIG_SPL_DM=y CONFIG_BOOTCOUNT_LIMIT=y CONFIG_BOOTCOUNT_ENV=y CONFIG_DFU_NAND=y CONFIG_MMC_OMAP_HS=y CONFIG_MTD=y CONFIG_MTD_RAW_NAND=y -CONFIG_SPI_FLASH=y +CONFIG_DM_SPI_FLASH=y CONFIG_SPI_FLASH_WINBOND=y CONFIG_MTD_UBI_FASTMAP=y CONFIG_MTD_UBI_FASTMAP_AUTOCONVERT=1 CONFIG_PHY_SMSC=y CONFIG_DRIVER_TI_CPSW=y CONFIG_SPI=y +CONFIG_DM_SPI=y CONFIG_OMAP3_SPI=y CONFIG_USB=y CONFIG_USB_MUSB_HOST=y -- 2.39.5