From 9c64e3958aef2c6ff8706a2250ac21baf6a4f44c Mon Sep 17 00:00:00 2001 From: Josua Mayer Date: Thu, 19 May 2022 12:31:58 +0300 Subject: [PATCH] ARM: dts: imx6qdl-sr-som: add support for alternate phy addresses The Cubox has an unstable phy address - which can appear at either address 0 (intended) or 4 (unintended). SoM revision 1.9 has replaced the ar8035 phy with an adin1300, which will always appear at address 1. Change the reg property of the phy node to the magic value 0xffffffff, which indicates to the generic phy driver that all addresses should be probed. That allows the same node (which is pinned by phy-handle) to match either the AR8035 PHY at both possible addresses, as well as the new one at address 1. Also add the new adi,phy-output-clock property for enabling the 125MHz clock used by the fec ethernet controller, as submitted to Linux [1]. Linux solves this problem differently: For the ar8035 phy it will probe both phy nodes in device-tree in order, and use the one that succeeds. For the new adin1300 it expects U-Boot to patch the status field in the DTB before booting While at it also sync the reset-delay with the upstream Linux dtb. [1] https://patchwork.kernel.org/project/netdevbpf/patch/20220428082848.12191-4-josua@solid-run.com/ Signed-off-by: Josua Mayer --- arch/arm/dts/imx6qdl-sr-som.dtsi | 17 +++++++++++++++-- 1 file changed, 15 insertions(+), 2 deletions(-) diff --git a/arch/arm/dts/imx6qdl-sr-som.dtsi b/arch/arm/dts/imx6qdl-sr-som.dtsi index b06577808f..c20bed2721 100644 --- a/arch/arm/dts/imx6qdl-sr-som.dtsi +++ b/arch/arm/dts/imx6qdl-sr-som.dtsi @@ -55,7 +55,13 @@ pinctrl-0 = <&pinctrl_microsom_enet_ar8035>; phy-handle = <&phy>; phy-mode = "rgmii-id"; - phy-reset-duration = <2>; + + /* + * The PHY seems to require a long-enough reset duration to avoid + * some rare issues where the PHY gets stuck in an inconsistent and + * non-functional state at boot-up. 10ms proved to be fine . + */ + phy-reset-duration = <10>; phy-reset-gpios = <&gpio4 15 GPIO_ACTIVE_LOW>; status = "okay"; @@ -64,8 +70,15 @@ #size-cells = <0>; phy: ethernet-phy@0 { - reg = <0>; + /* + * The PHY can appear either: + * - AR8035: at address 0 or 4 + * - ADIN1300: at address 1 + * Actual address being detected at runtime. + */ + reg = <0xffffffff>; qca,clk-out-frequency = <125000000>; + adi,phy-output-clock = "125mhz-free-running"; }; }; }; -- 2.39.5