From 8d2d8085a0c4d641f6ded9764291cf4dcbcd834e Mon Sep 17 00:00:00 2001 From: Russell King Date: Sat, 15 Feb 2020 15:50:09 +0000 Subject: [PATCH] net: phylink: clarify flow control settings in documentation Clarify the expected flow control settings operation in the phylink documentation for each negotiation mode. Signed-off-by: Russell King Reviewed-by: Andrew Lunn Signed-off-by: David S. Miller --- include/linux/phylink.h | 26 ++++++++++++++++++-------- 1 file changed, 18 insertions(+), 8 deletions(-) diff --git a/include/linux/phylink.h b/include/linux/phylink.h index 0d6073c2b2b75..812357c03df44 100644 --- a/include/linux/phylink.h +++ b/include/linux/phylink.h @@ -152,13 +152,20 @@ void mac_pcs_get_state(struct phylink_config *config, * guaranteed to be correct, and so any mac_config() implementation must * never reference these fields. * + * In all negotiation modes, as defined by @mode, @state->pause indicates the + * pause settings which should be applied as follows. If %MLO_PAUSE_AN is not + * set, %MLO_PAUSE_TX and %MLO_PAUSE_RX indicate whether the MAC should send + * pause frames and/or act on received pause frames respectively. Otherwise, + * the results of in-band negotiation/status from the MAC PCS should be used + * to control the MAC pause mode settings. + * * The action performed depends on the currently selected mode: * * %MLO_AN_FIXED, %MLO_AN_PHY: - * Configure the specified @state->speed, @state->duplex and - * @state->pause (%MLO_PAUSE_TX / %MLO_PAUSE_RX) modes over a link - * specified by @state->interface. @state->advertising may be used, - * but is not required. Other members of @state must be ignored. + * Configure the specified @state->speed and @state->duplex over a link + * specified by @state->interface. @state->advertising may be used, but + * is not required. Pause modes as above. Other members of @state must + * be ignored. * * Valid state members: interface, speed, duplex, pause, advertising. * @@ -170,11 +177,14 @@ void mac_pcs_get_state(struct phylink_config *config, * mac_pcs_get_state() callback. Changes in link state must be made * by calling phylink_mac_change(). * + * Interface mode specific details are mentioned below. + * * If in 802.3z mode, the link speed is fixed, dependent on the - * @state->interface. Duplex is negotiated, and pause is advertised - * according to @state->an_enabled, @state->pause and - * @state->advertising flags. Beware of MACs which only support full - * duplex at gigabit and higher speeds. + * @state->interface. Duplex and pause modes are negotiated via + * the in-band configuration word. Advertised pause modes are set + * according to the @state->an_enabled and @state->advertising + * flags. Beware of MACs which only support full duplex at gigabit + * and higher speeds. * * If in Cisco SGMII mode, the link speed and duplex mode are passed * in the serial bitstream 16-bit configuration word, and the MAC -- 2.39.5