dt-bindings: net: micrel: Revert latency support and timestamping check

Revert latency support from binding.
Based on the discussion[1], the DT is the wrong place to have the
lantecies for the PHY.

[1] https://lkml.org/lkml/2022/3/4/325

Fixes: c3075dfed92e82 ("dt-bindings: net: micrel: Configure latency values and timestamping check for LAN8814 phy")
Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/Documentation/devicetree/bindings/net/micrel.txt b/Documentation/devicetree/bindings/net/micrel.txt
index c5ab62c391335862c4da0bb28c4523fe6f24db5c..8d157f0295a502fd326eab4e2196f17654d8b484 100644 (file)
--- a/Documentation/devicetree/bindings/net/micrel.txt
+++ b/Documentation/devicetree/bindings/net/micrel.txt
@@ -45,20 +45,3 @@ Optional properties:
 
        In fiber mode, auto-negotiation is disabled and the PHY can only work in
        100base-fx (full and half duplex) modes.
-
- - lan8814,ignore-ts: If present the PHY will not support timestamping.
-
-       This option acts as check whether Timestamping is supported by
-       hardware or not. LAN8814 phy support hardware tmestamping.
-
- - lan8814,latency_rx_10: Configures Latency value of phy in ingress at 10 Mbps.
-
- - lan8814,latency_tx_10: Configures Latency value of phy in egress at 10 Mbps.
-
- - lan8814,latency_rx_100: Configures Latency value of phy in ingress at 100 Mbps.
-
- - lan8814,latency_tx_100: Configures Latency value of phy in egress at 100 Mbps.
-
- - lan8814,latency_rx_1000: Configures Latency value of phy in ingress at 1000 Mbps.
-
- - lan8814,latency_tx_1000: Configures Latency value of phy in egress at 1000 Mbps.