crypto: qat - enable interrupts only after ISR allocation

Enable device interrupts after the setup of the interrupt handlers.

Signed-off-by: Marco Chiappero <marco.chiappero@intel.com>
Co-developed-by: Giovanni Cabiddu <giovanni.cabiddu@intel.com>
Signed-off-by: Giovanni Cabiddu <giovanni.cabiddu@intel.com>
Reviewed-by: Fiona Trahe <fiona.trahe@intel.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>

diff --git a/drivers/crypto/qat/qat_common/adf_init.c b/drivers/crypto/qat/qat_common/adf_init.c
index 744c40351428da6ceeda9f01bcdcbd0798cff732..14e9f3b22c609d998c7b84fd0a4f5c45ccce64dd 100644 (file)
--- a/drivers/crypto/qat/qat_common/adf_init.c
+++ b/drivers/crypto/qat/qat_common/adf_init.c
@@ -88,8 +88,6 @@ int adf_dev_init(struct adf_accel_dev *accel_dev)
                return -EFAULT;
        }
 
-       hw_data->enable_ints(accel_dev);
-
        if (adf_ae_init(accel_dev)) {
                dev_err(&GET_DEV(accel_dev),
                        "Failed to initialise Acceleration Engine\n");
@@ -110,6 +108,8 @@ int adf_dev_init(struct adf_accel_dev *accel_dev)
        }
        set_bit(ADF_STATUS_IRQ_ALLOCATED, &accel_dev->status);
 
+       hw_data->enable_ints(accel_dev);
+
        /*
         * Subservice initialisation is divided into two stages: init and start.
         * This is to facilitate any ordering dependencies between services