obj-$(CONFIG_HUGETLB_PAGE) += hugetlbpage.o
obj-$(CONFIG_PTDUMP_CORE) += ptdump.o
obj-$(CONFIG_PTDUMP_DEBUGFS) += ptdump_debugfs.o
- obj-$(CONFIG_NUMA) += numa.o
+obj-$(CONFIG_TRANS_TABLE) += trans_pgd.o
obj-$(CONFIG_DEBUG_VIRTUAL) += physaddr.o
obj-$(CONFIG_ARM64_MTE) += mteswap.o
KASAN_SANITIZE_physaddr.o += n
/* Reserve from the start of the kernel to the end of the kernel */
memblock_reserve(vmlinux_start, vmlinux_end - vmlinux_start);
- max_pfn = PFN_DOWN(memblock_end_of_DRAM());
+ dram_end = memblock_end_of_DRAM();
+
+ /*
+ * memblock allocator is not aware of the fact that last 4K bytes of
+ * the addressable memory can not be mapped because of IS_ERR_VALUE
+ * macro. Make sure that last 4k bytes are not usable by memblock
+ * if end of dram is equal to maximum addressable memory.
+ */
+ if (max_mapped_addr == (dram_end - 1))
+ memblock_set_current_limit(max_mapped_addr - 4096);
+
+ max_pfn = PFN_DOWN(dram_end);
max_low_pfn = max_pfn;
dma32_phys_limit = min(4UL * SZ_1G, (unsigned long)PFN_PHYS(max_low_pfn));
- set_max_mapnr(max_low_pfn);
+ set_max_mapnr(max_low_pfn - ARCH_PFN_OFFSET);
- #ifdef CONFIG_BLK_DEV_INITRD
- setup_initrd();
- #endif /* CONFIG_BLK_DEV_INITRD */
-
+ reserve_initrd_mem();
/*
- * Avoid using early_init_fdt_reserve_self() since __pa() does
+ * If DTB is built in, no need to reserve its memblock.
+ * Otherwise, do reserve it but avoid using
+ * early_init_fdt_reserve_self() since __pa() does
* not work for DTB pointers that are fixmap addresses
*/
- memblock_reserve(dtb_early_pa, fdt_totalsize(dtb_early_va));
+ if (!IS_ENABLED(CONFIG_BUILTIN_DTB))
+ memblock_reserve(dtb_early_pa, fdt_totalsize(dtb_early_va));
early_init_fdt_scan_reserved_mem();
dma_contiguous_reserve(dma32_phys_limit);
kasan_populate_early_shadow((void *)KASAN_SHADOW_START,
(void *)kasan_mem_to_shadow((void *)
- VMALLOC_END));
+ VMEMMAP_END));
+ if (IS_ENABLED(CONFIG_KASAN_VMALLOC))
+ kasan_shallow_populate(
+ (void *)kasan_mem_to_shadow((void *)VMALLOC_START),
+ (void *)kasan_mem_to_shadow((void *)VMALLOC_END));
+ else
+ kasan_populate_early_shadow(
+ (void *)kasan_mem_to_shadow((void *)VMALLOC_START),
+ (void *)kasan_mem_to_shadow((void *)VMALLOC_END));
for_each_mem_range(i, &_start, &_end) {
- void *start = (void *)_start;
- void *end = (void *)_end;
+ void *start = (void *)__va(_start);
+ void *end = (void *)__va(_end);
if (start >= end)
break;