net: dsa: microchip: Always set regmap stride to 1

The regmap stride is set to 1 for regmap describing 8bit registers already.
However, for 16/32/64bit registers, the stride is 2/4/8 respectively. This
is not correct, as the switch protocol supports unaligned register reads
and writes and the KSZ87xx even uses such unaligned register accesses to
read e.g. MIB counter.

This patch fixes MIB counter access on KSZ87xx.

Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Andrew Lunn <andrew@lunn.ch>
Cc: David S. Miller <davem@davemloft.net>
Cc: Florian Fainelli <f.fainelli@gmail.com>
Cc: George McCollister <george.mccollister@gmail.com>
Cc: Tristram Ha <Tristram.Ha@microchip.com>
Cc: Vivien Didelot <vivien.didelot@savoirfairelinux.com>
Cc: Woojung Huh <woojung.huh@microchip.com>
Fixes: fdbba6444413 ("net: dsa: microchip: Initial SPI regmap support")
Fixes: 679a12c76f60 ("net: dsa: microchip: Factor out regmap config generation into common header")
Reviewed-by: George McCollister <george.mccollister@gmail.com>
Tested-by: George McCollister <george.mccollister@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/dsa/microchip/ksz_common.h b/drivers/net/dsa/microchip/ksz_common.h
index a24d8e61fbe7b6739e9de6764db26ba876f982ac..dd60d0837fc6db51f744db06fb26f1eeefb83673 100644 (file)
--- a/drivers/net/dsa/microchip/ksz_common.h
+++ b/drivers/net/dsa/microchip/ksz_common.h
@@ -303,7 +303,7 @@ static inline void ksz_pwrite32(struct ksz_device *dev, int port, int offset,
        {                                                               \
                .name = #width,                                         \
                .val_bits = (width),                                    \
-               .reg_stride = (width) / 8,                              \
+               .reg_stride = 1,                                        \
                .reg_bits = (regbits) + (regalign),                     \
                .pad_bits = (regpad),                                   \
                .max_register = BIT(regbits) - 1,                       \