net: phy: at803x: move page selection fix to config_init

The fix to select the copper page on AR8031 was being done in the probe
function rather than config_init, so it would not be redone after resume
from suspend. Move this to config_init so it is always redone when
needed.

Fixes: c329e5afb42f ("net: phy: at803x: select correct page on config init")
Signed-off-by: Robert Hancock <robert.hancock@calian.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index 5b6c0d120e09e2b00347c230dad696d884f86b83..052b2eb9f101fdcacd12569e995116c4f397000c 100644 (file)
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -784,25 +784,7 @@ static int at803x_probe(struct phy_device *phydev)
                        return ret;
        }
 
-       /* Some bootloaders leave the fiber page selected.
-        * Switch to the copper page, as otherwise we read
-        * the PHY capabilities from the fiber side.
-        */
-       if (phydev->drv->phy_id == ATH8031_PHY_ID) {
-               phy_lock_mdio_bus(phydev);
-               ret = at803x_write_page(phydev, AT803X_PAGE_COPPER);
-               phy_unlock_mdio_bus(phydev);
-               if (ret)
-                       goto err;
-       }
-
        return 0;
-
-err:
-       if (priv->vddio)
-               regulator_disable(priv->vddio);
-
-       return ret;
 }
 
 static void at803x_remove(struct phy_device *phydev)
@@ -912,6 +894,22 @@ static int at803x_config_init(struct phy_device *phydev)
 {
        int ret;
 
+       if (phydev->drv->phy_id == ATH8031_PHY_ID) {
+               /* Some bootloaders leave the fiber page selected.
+                * Switch to the copper page, as otherwise we read
+                * the PHY capabilities from the fiber side.
+                */
+               phy_lock_mdio_bus(phydev);
+               ret = at803x_write_page(phydev, AT803X_PAGE_COPPER);
+               phy_unlock_mdio_bus(phydev);
+               if (ret)
+                       return ret;
+
+               ret = at8031_pll_config(phydev);
+               if (ret < 0)
+                       return ret;
+       }
+
        /* The RX and TX delay default is:
         *   after HW reset: RX delay enabled and TX delay disabled
         *   after SW reset: RX delay enabled, while TX delay retains the
@@ -941,12 +939,6 @@ static int at803x_config_init(struct phy_device *phydev)
        if (ret < 0)
                return ret;
 
-       if (phydev->drv->phy_id == ATH8031_PHY_ID) {
-               ret = at8031_pll_config(phydev);
-               if (ret < 0)
-                       return ret;
-       }
-
        /* Ar803x extended next page bit is enabled by default. Cisco
         * multigig switches read this bit and attempt to negotiate 10Gbps
         * rates even if the next page bit is disabled. This is incorrect