The driver sets up AUX link at probe time, but, for some reason, also
sets the main link's number of lanes using tc->link.base.num_lanes. This
is not needed nor correct, as the number of lanes has not been decided
yet. The number of lanes will be set later during main link setup.
Modify aux_link_setup so that it does not use tc->link, and thus makes
aux setup independent of the link probing.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Andrzej Hajda <a.hajda@samsung.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Andrzej Hajda <a.hajda@samsung.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190528082747.3631-7-tomi.valkeinen@ti.com
unsigned long rate;
u32 value;
int ret;
- u32 dp_phy_ctrl;
rate = clk_get_rate(tc->refclk);
switch (rate) {
value |= SYSCLK_SEL_LSCLK | LSCLK_DIV_2;
tc_write(SYS_PLLPARAM, value);
- dp_phy_ctrl = BGREN | PWR_SW_EN | PHY_A0_EN;
- if (tc->link.base.num_lanes == 2)
- dp_phy_ctrl |= PHY_2LANE;
- tc_write(DP_PHY_CTRL, dp_phy_ctrl);
+ tc_write(DP_PHY_CTRL, BGREN | PWR_SW_EN | PHY_A0_EN);
/*
* Initially PLLs are in bypass. Force PLL parameter update,
if (ret == -ETIMEDOUT) {
dev_err(tc->dev, "Timeout waiting for PHY to become ready");
return ret;
- } else if (ret)
+ } else if (ret) {
goto err;
+ }
/* Setup AUX link */
tc_write(DP0_AUXCFG1, AUX_RX_FILTER_EN |