This converts the following to Kconfig:
CONFIG_BOARD_ECC_SUPPORT
Signed-off-by: Tom Rini <trini@konsulko.com>
config TARGET_DB_MV784MP_GP
bool "Support db-mv784mp-gp"
+ select BOARD_ECC_SUPPORT
select MV78460
config TARGET_DS414
config TARGET_MAXBCM
bool "Support maxbcm"
+ select BOARD_ECC_SUPPORT
select MV78460
config TARGET_THEADORABLE
device will still hang - it doesn't make sense to reset the board
in such a case.
+config BOARD_ECC_SUPPORT
+ bool
+
config SYS_BOARD
default "clearfog" if TARGET_CLEARFOG
default "helios4" if TARGET_HELIOS4
/* Enable DDR support in SPL (DDR3 training from Marvell bin_hdr) */
#define CONFIG_SPD_EEPROM 0x4e
-#define CONFIG_BOARD_ECC_SUPPORT /* this board supports ECC */
#endif /* _CONFIG_DB_MV7846MP_GP_H */
/* Enable DDR support in SPL (DDR3 training from Marvell bin_hdr) */
#define CONFIG_SYS_SDRAM_SIZE SZ_1G
-#define CONFIG_BOARD_ECC_SUPPORT /* this board supports ECC */
#endif /* _CONFIG_DB_MV7846MP_GP_H */