perf/x86: Reset destroy callback on event init failure

perf/x86: Reset destroy callback on event init failure

perf_init_event tries multiple init callbacks and does not reset the
event state between tries. When x86_pmu_event_init runs, it
unconditionally sets the destroy callback to hw_perf_event_destroy. On
the next init attempt after x86_pmu_event_init, in perf_try_init_event,
if the pmu's capabilities includes PERF_PMU_CAP_NO_EXCLUDE, the destroy
callback will be run. However, if the next init didn't set the destroy
callback, hw_perf_event_destroy will be run (since the callback wasn't
reset).

Looking at other pmu init functions, the common pattern is to only set
the destroy callback on a successful init. Resetting the callback on
failure tries to replicate that pattern.

This was discovered after commit df179b3191d3 ("perf/x86/amd/ibs: Extend
PERF_PMU_CAP_NO_EXCLUDE to IBS Op") when the second (and only second)
run of the perf tool after a reboot results in 0 samples being
generated. The extra run of hw_perf_event_destroy results in
active_events having an extra decrement on each perf run. The second run
has active_events == 0 and every subsequent run has active_events < 0.
When active_events == 0, the NMI handler will early-out and not record
any samples.

Signed-off-by: Anand K Mistry <amistry@google.com>
Signed-off-by: Peter Zijlstra (Intel) <peterz@infradead.org>
Link: https://lkml.kernel.org/r/20210929170405.1.I078b98ee7727f9ae9d6df8262bad7e325e40faf0@changeid