bus: mhi: core: Process execution environment changes serially

bus: mhi: core: Process execution environment changes serially

In current design, whenever the BHI interrupt is fired, the
execution environment is updated. This can cause race conditions
and impede ongoing power up/down processing. For example, if a
power down is in progress, MHI host updates to a local "disabled"
execution environment. If a BHI interrupt fires later, that value
gets replaced with one from the BHI EE register. This impacts the
controller as it does not expect multiple RDDM execution
environment change status callbacks as an example. Another issue
would be that the device can enter mission mode and the execution
environment is updated, while device creation for SBL channels is
still going on due to slower PM state worker thread run, leading
to multiple attempts at opening the same channel.

Ensure that EE changes are handled only from appropriate places
and occur one after another and handle only PBL modes or RDDM EE
changes as critical events directly from the interrupt handler.
Simplify handling by waiting for SYS ERROR before handling RDDM.
This also makes sure that we use the correct execution environment
to notify the controller driver when the device resets to one of
the PBL execution environments.

Signed-off-by: Bhaumik Bhatt <bbhatt@codeaurora.org>
Reviewed-by: Loic Poulain <loic.poulain@linaro.org>
Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Link: https://lore.kernel.org/r/1614208985-20851-4-git-send-email-bbhatt@codeaurora.org
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>